Bell Bike Full-Face Helmet User Manual download pdf (Page 5)

6 7

2. If you can remove the helmet by rolling it backwards far enough

to expose your forehead or forward enough to block your vision,

repeat STEP 2.

3. If, after repeating STEP 2, you can still remove the helmet, by rolling

it forward far enough to block your vision or backward enough to

expose your forehead, DO NOT USE THIS HELMET. Replace the

helmet with a smaller size.

4. If you cannot remove this helmet and it does

not roll backward far enough to expose your

forehead or forward enough to block your vision,

you have a proper t.

REMOVING THE HELMET

1. Un-thread chin strap from Double D-Ring or

release buckle.

2. Remove the helmet.

ADJUSTING AND REMOVING THE VISOR

1. The visor is held in place by 2 screws

2. Loosen both screws, adjust the visor to the

desired location and then retighten the screws.

You can use an Allen key, athead screwdriver

or a coin.

REMOVING THE VISOR

1. Take out the screws.

2. Carefully pull the visor away from the helmet.

IF YOU HAVE AN INTEGRATED CAMERA MOUNT

The top vent is designed to receive both GoPro

(Figure 4) and Contour

(Figure 5) camera

mounting brackets. The GoPro breakaway insert

can be replaced with a Contour breakaway insert

Figure 4

Figure 5

(Figure 5). To replace GoPro breakaway insert apply rm pressure to center

of insert and unsnap it from bracket. Firmly snap Contour breakaway insert

into center of bracket.

ATTACH AND REMOVE CAMERA MOUNT

1. Snap selected bracket into the top vent as shown.

2. To remove bracket, press button and slide out bracket.

IF YOU HAVE A TRANSFER-9 CAMERA MOUNT

1. Attach the separate part to the top of the helmet.

2. Follow instructions above to replace GoPro insert with Contour

breakaway insert.

TEST RIDE

Once you are satised with the t, put on your helmet and take an

extended test ride. Immediately after the test ride double-check the

positioning of the straps. If the helmet was comfortable, remained rmly

in place, the straps stayed properly adjusted, and you are satised with

the positioning of your visor, your helmet is ready to be used. If the helmet

felt uncomfortable, or the straps or visor need adjusting, repeat STEPS 2

through 5 as necessary to correct the problem. If you are still unable to

adjust your helmet to meet these requirements, or if you have any other

problems, DO NOT continue to use the helmet. Replace it with a different

size or model.

CARING FOR YOUR HELMET

Cleaning: Helmets can be damaged by many available cleaners,

especially Petroleum based solvents. Clean the helmet using a soft cloth or

sponge, warm water and mild soap.

Storage: Excessive heat can damage the helmet. In direct sunlight,

dark gear bags and automobile trunks can get hot enough to cause heat

1 2 3 4 5 6 7 8 9 10 ... 40 41

Comments to this Manuals

No comments

Bell Bike Full-Face Helmet User Manual Page 5

Comments to this Manuals

Related products and manuals for Sports and recreation Bell Bike Full-Face Helmet