Bell EXPRESSVU 3700 Installation Guide download pdf (Page 54)

Page I-39

Installation and Setup

Assembling the 120cm Dish

8. Attach the two struts to the mast with the supplied hardware. Tighten the bolt for a

snug fit that still allows some slight movement of the struts.

9. Position the foot of each strut squarely on the mounting surface and mark the holes

for drilling. Prior to drilling the strut holes, confirm with the spirit level that the mast

is still vertical. This is a critical check to ensure proper alignment.

10. Drill the holes while the strut feet are still properly in place.

(Alternatively, you can mark the holes, move the struts slightly, then drill.)

11.Attach the mount with the 4 fasteners; seal the holes with silicone to prevent water

damage to your dwelling.

12. Tighten the strut attachment bolt which was installed in step 8. Place the level on

the front face of the short curved portion of the mast to confirm that the mast is still

vertical. There are no further adjustments to make to the mount.

If you have trouble fastening the mount to a surface, try mounting a solid

piece of wood to your dwelling’s surface first, then fastening the mount to

the wood.

STEP 3.4C: INSTALLING THE DISH ON THE MOUNT

(120 CM DISH)

You have installed the mount on your dwelling and you have pre-assembled the antenna

unit, ready to be installed on the mount.

There are just a few steps here:

1. Slide the antenna assembly over the mast.

2. Lightly tighten the four nuts on the back of the mast clamp, so that the antenna can

pivot in the East/West directions but not be loose.

3. You are ready to carry out the antenna alignments, as soon as the wiring in Step 3.4D

is completed.

STEP 3.4D: CONNECTING THINGS TOGETHER (120 CM DISH)

The wiring is accomplished as follows:

1. Thread a length of coaxial cable through the

mast pipe and mast clamp as shown in the

diagram.

2. Route the coaxial cable through the feed

support tube as shown in the diagram.

COAXIAL CABLE

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 82 83

No comments

Bell EXPRESSVU 3700 Installation Guide Page 54