Bell EXPRESSVU 3700 User's Guide download pdf (Page 3)

Page 4-3

PHONO (RCA) AUDIO/VIDEO CONNECTIONS

(BETTER PICTURE AND SOUND)

Cable Connectors on

Receiver

The back panel phono (RCA) audio/video connections provide better picture quality and

stereo sound. The phono (RCA) audio/video cable is available as a single cable with

three connectors on either end, or as three separate cables. The connectors are colour-

coded according to the type of signal they carry: the yellow connector carries the video

signal, the white connector carries the left audio signal, and the red connector carries the

right audio signal. If the TV only has one input connection for this type of audio,

connect it to the right (R) phono (RCA) audio connection on the receiver.

If you use the phono (RCA) audio/video connections to connect the receiver with other

devices, then depending on the type of device that you connect to the receiver you may

need to use the menus displayed by each device to change the input from local broadcast

TV to satellite TV. See the user guides that came with the other devices for more

information.

CHANNEL 3/4 SWITCH

If you use the TV Set Out (RF or VHF Connection) to wire the

receiver to a television, set this switch to the channel for the signal

output. Select a channel that is not being used by a cable or local

television station. Note: If you connect the receiver to a VCR that

also uses a channel switch, set both switches to the same channel.

TV ANTENNA/CABLE IN (RF OR VHF)

Connect your broadcast TV antenna or cable TV connection here to

switch between satellite programming and your local or cable TV.

When the satellite receiver is turned OFF or you press the

TV/Video button on the remote, you have access to your local

TV stations from this connection.

Reference

Wiring The System Together

TV ANTENNA/

CABLE IN

TV ANTENNA/

CABLE IN

1 2 3 4 5 6 7 8 ... 17 18

No comments

Bell EXPRESSVU 3700 User's Guide Page 3